Jonas Gorski e9390dcf23
ipq806x: ap148/r7500: fix eth0 for non gige speeds ...
Eth0 is attached to mac0 of the switch with a fixed link and and not to
phy4 in single phy mode, so configuring it to anything but 1000FD will
break the connection, which will happen if a only 100 Mbit capapble device
is plugged into the wan port.
Fix this by not taking the state from phy4 and just configuring a fixed link
for eth0.
Signed-off-by: Jonas Gorski <jogo@openwrt.org >
SVN-Revision: 47695
2015-12-02 22:16:23 +00:00
2015-08-30 12:17:54 +00:00
2015-07-14 09:57:45 +00:00
2015-10-25 17:32:01 +00:00
2015-12-02 21:52:41 +00:00
2015-11-22 19:06:07 +00:00
2015-10-04 11:34:39 +00:00
2015-08-17 16:10:49 +00:00
2015-08-30 12:17:56 +00:00
2015-08-05 13:55:52 +00:00
2015-12-02 18:51:12 +00:00
2015-12-02 21:52:41 +00:00
2015-11-24 18:59:28 +00:00
2015-12-02 21:52:41 +00:00
2015-11-01 13:45:57 +00:00
2015-07-22 12:51:11 +00:00
2015-12-02 21:52:41 +00:00
2015-11-20 05:21:19 +00:00
2015-12-02 22:16:23 +00:00
2015-10-25 17:32:01 +00:00
2015-11-18 21:35:04 +00:00
2015-12-02 17:20:39 +00:00
2015-10-31 09:30:57 +00:00
2015-11-01 13:45:57 +00:00
2015-12-02 21:52:41 +00:00
2015-12-02 17:35:37 +00:00
2015-11-30 10:43:31 +00:00
2015-09-23 18:40:42 +00:00
2015-04-23 22:31:36 +00:00
2015-11-15 21:33:33 +00:00
2015-11-02 10:17:09 +00:00
2015-10-09 07:46:12 +00:00
2015-09-08 12:31:04 +00:00
2015-11-24 18:29:14 +00:00
2015-04-12 20:48:13 +00:00
2015-08-05 13:55:52 +00:00
2015-03-06 07:56:34 +00:00
2015-11-28 23:26:03 +00:00
2015-10-26 09:00:35 +00:00
2015-10-30 22:31:47 +00:00
2015-12-02 21:52:41 +00:00
2015-09-28 12:22:35 +00:00
2015-11-08 20:39:24 +00:00
2015-11-01 13:45:57 +00:00
e9390dcf23