mirror of
https://github.com/Telecominfraproject/OpenCellular.git
synced 2026-01-08 16:41:55 +00:00
ffd1ee934f
This commit changes the behaviour of handling the CCD_MODE_L pin. When Cr50 is not in CCD mode, it will stop driving the pin and turn it into an input. This allows the pin to be driven by the EC. Cr50 will then poll the CCD_MODE_L pin to see when it is pulled low and then enter CCD mode. Once the pin is deasserted, CCD mode is disabled. However, when Cr50 itself makes the decision to enter CCD mode, it changes the pin from an input to an output and drives the pin low. NOTE: The rdd interrupt does not directly trigger CCD mode, but now drives the pin low. A side-effect of the pin going low is that CCD is enabled. Once Cr50 decides to leave CCD mode, it then reconfigures the pin to be setup as an input again. CQ-DEPEND=CL:448988 BUG=b:35804738 BRANCH=cr50 TEST=Flash dev board, use `ccd` console command to both enable and disable CCD. Verify that when CCD is enabled, the state of DIOM1 does not disable CCD. Verify that when CCD is disabled, pulling DIOM1 low enables CCD. Letting it float disables CCD. TEST=Verify that CCD mode is reflected in the device state. Change-Id: I44645f28b362977ca6a502b646e4f4ff1a7430c7 Signed-off-by: Aseda Aboagye <aaboagye@google.com> Reviewed-on: https://chromium-review.googlesource.com/448161 Commit-Ready: Aseda Aboagye <aaboagye@chromium.org> Tested-by: Aseda Aboagye <aaboagye@chromium.org> Reviewed-by: Vadim Bendebury <vbendeb@chromium.org>