Enable CONFIG_LEDS_TRIGGER_HEARTBEAT to allow LED heartbeat
functionality when device goes offline. Without this kernel option,
the LED trigger mechanism was unavailable, preventing the LED from
flashing to indicate offline status.
Fixes: WIFI-14646
Signed-off-by: John Crispin <john@phrozen.org>
LAN switch exposes single eth1 instead of per-port interfaces for RAP750W-311A.
Using VLAN to separate LAN to each physical port for RAP750W-311A.
Fixes: WIFI-15163
Signed-off-by: jackcybertan <jack.tsai@cybertan.com.tw>
Reverse byte order in non-OUI part of MAC address to prevent overlap
when MBSSID is enabled. Swaps bytes 3 and 5 and masks lower nibble
of byte 5 before applying index XOR.
Signed-off-by: John Crispin <john@phrozen.org>
To fix EMI and avoid Ethernet RX stuck after reboot for Zyxel NWA130BE.
Ethernet Rx stuck was sometimes happened when we do stress reboot,
need to adjust the amplitude level of SGMII for CPU and QCA8385 side.
And those settings come from the result that Zyxel HW team and Manufacturer
co-work to fine tune for NWA130BE.
Signed-off-by: YenLin Pan <YenLin.Pan@zyxel.com.tw>
* Reduce the i2c frequency to enable the encryption chip to be recognized
* Add USB xr Serial driver and init gps uart param
* Factory reset when switching wifi mode
* SFP gpio should be input mode
Fixes: WIFI-14789
Signed-off-by: Justin.Guo <guoxijun@actiontec.com>
1.Change the WiFi temperature threshold.
2.Use single antenna when temperature is too high.
Fixes: WIFI-14788
Signed-off-by: Justin.Guo <guoxijun@actiontec.com>
If MPSK is enabled on any interface, `ssid.mpsk` should be true.
Prevents overwriting true with a false value when multiple interfaces
share the same SSID.
Also allow handling of the 'reload' event even when MPSK is not enabled,
to ensure config reloads are not skipped, e.g. when configuration is empty.
Fixes: WIFI-14484
Signed-off-by: Marek Kwaczynski <marek@shasta.cloud>
After roaming to EAP105, the roaming frames were exchanged successfully,
but the STA sent a deauthentication frame to the AP with an "INVALID IE" error.
The RSNXE subfield in the FTIE was set in the Reassociation Response frame.
The STA validated the Reassociation frame and was unable to process the
RSNXE subfield.
Modified SAE options (sae_pwe=4 and sae_require_pmf=0).
Fixes: WIFI-14544
Signed-off-by: Marek Kwaczynski <marek@shasta.cloud>
When using psk2-radius in combination with enhanced MPSK,
the passphrase was not properly propagated to user scripts
via the ucode interface, because the PSK field was not set
in the connected station context.
This patch fixes that by copying the passphrase into the
psk field.
Signed-off-by: Marek Kwaczynski <marek@shasta.cloud>
For the Edgecore EAP-105 platform, configure the 2.4GHz, 5GHz,
and 6GHz WLAN interfaces to use MAC addresses derived
from the base WAN MAC address.
Fixes: WIFI-14624
Signed-off-by: Marek Kwaczynski <marek@shasta.cloud>
* While Roaming the AP couldn't find the wildcard R0KH and R1KH ids,
which are required by Fast transistion.
* Issue caused by the placement of conf parser in the invalid location.
Fixes: WIFI-14544
Signed-off-by: Marek Kwaczynski <marek@shasta.cloud>
