The old backlight_x86 code did
(backlight enable) = (lid is open) && (GPIO request from AP)
Newer systems will AND those signals in hardware. Support those
systems by separating CONFIG_BACKLIGHT_LID and
CONFIG_BACKLIGHT_REQ_GPIO, and add tests for the case where the enable
signal is dependent only on the lid position.
BUG=chrome-os-partner:22960
BRANCH=none
TEST=pass unit tests
Change-Id: I1909426e49f00a8acd5047fd88c801cba1dacd76
Reviewed-on: https://chromium-review.googlesource.com/170925
Tested-by: Randall Spangler <rspangler@chromium.org>
Reviewed-by: Bill Richardson <wfrichar@chromium.org>
Commit-Queue: Randall Spangler <rspangler@chromium.org>
This should have all the correct GPIO mappings.
Chipset and charger tasks are currently disabled, until we bring up
the voltage rails and I2C communication.
BUG=chrome-os-partner:22895
BRANCH=none
TEST=compiles; everything else needs to wait until we get hardware
Change-Id: Iea49fe7ab8bd17f61c8cc6c71f236a503418ee28
Signed-off-by: Randall Spangler <rspangler@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/170540
Reviewed-by: Vic Yang <victoryang@chromium.org>
This code is not LM4-specific, it's x86-specific. So it doesn't
belong in chip/lm4. Put it in its own module rather than leaving it
in switch.c, since some x86 systems may need the power button state
machine but not the backlight-enable passthru.
BUG=chrome-os-partner:18343
BRANCH=none
TEST=Quickly run a magnet over the lid switch; the backlight goes off and then
back on.
Change-Id: I72f7139b73f91539dcfbe6b5cb6d56587ab66fde
Signed-off-by: Randall Spangler <rspangler@chromium.org>
Reviewed-on: https://gerrit.chromium.org/gerrit/61595
Reviewed-by: Bill Richardson <wfrichar@chromium.org>
