mirror of
https://github.com/Telecominfraproject/OpenCellular.git
synced 2025-12-30 02:20:48 +00:00
17150b05ff
The device state machines aren't quite similar enough to use common
code. Split the AP state machine out, the way we split out the EC
state machine in the previous CL.
BUG=b:35587387
BRANCH=cr50
TEST=manual, with Cr50 strapped (or hard-coded) not to use platform reset
and not to use TPM reset to detect the AP:
Pull CCD_MODE_L low, so Cr50 detects/enables CCD
Pull AP_DETECT high.
Pull INT_AP_L low (with resistor).
Pull AP_DETECT low --> See 'AP off' message
gpioget --> INT_AP_L=0
ccd --> AP UART disabled
Pull AP_DETECT high --> See 'AP on' message
gpioget --> INT_AP_L=1
ccd --> AP UART RX+TX
Pull AP_DETECT low for <1 sec then back high
(don't see AP off/on message)
gpioget --> INT_AP_L=1
ccd --> AP UART RX+TX
Reboot with AP_DETECT still low -> AP off at 1 second
Reboot with AP_DETECT still low and then assert AP_DETECT
within a second -> AP on immediately
Repeat with Cr50 strapped/hard coded to use platform reset, but
using TPM_RST_L instead of AP_DETECT. Note that this will also
show TPM reset debugging output when TPM_RST_L is asserted.
Change-Id: Ief9e4e5f2585ff925de1595cc8fbd5306c94a806
Signed-off-by: Randall Spangler <rspangler@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/634248
Reviewed-by: Mary Ruthven <mruthven@chromium.org>
For an overview of the Embedded Controller firmware, refer to http://www.chromium.org/chromium-os/2014-firmware-summit For instructions on building from source, refer to http://www.chromium.org/chromium-os/ec-development/getting-started-building-ec-images-quickly