mirror of
https://github.com/Telecominfraproject/OpenCellular.git
synced 2026-01-13 03:15:06 +00:00
56ce828309
Currently, the charge state machine sets the power LED green the first time it hits IDLE. This causes the LED to briefly flash green when the adapter is inserted, because the state machine goes discharging->init->idle->charging. Instead, add a new idle0 state in between init and idle which does not set the power LED. This allows the state machine to go discharging->init->idle0->charging, so the LED only goes from off->yellow. If the system is actually fully charged, it'll go init->idle0->idle and show green. BUG=chrome-os-partner:14630 BRANCH=link TEST=manual - Remove adapter and allow system to discharge a bit - Insert adapter - Should see LED go from off directly to yellow - Wait for charge - Should see LED go green Change-Id: I9b77f01fad27c8574133211c9fe250486609f3c1 Signed-off-by: Randall Spangler <rspangler@chromium.org> Reviewed-on: https://gerrit.chromium.org/gerrit/34387 Reviewed-by: Rong Chang <rongchang@chromium.org>
- EC Lib
This wraps Blizzard driverlib and implements the EC chip interface defined
by Google. See below diagram for architecture.
+--------------------+
| Host BIOS/OS |
+--------------------+
---- host interface ----
+--------------------+
| Google EC features |
+--------------------+
---- chip interface ---- The interface is defined in
src/platform/ec/chip_interface/*.
+--------------------+ But the real implementation is in EC Lib.
| EC Lib |
+--------------------+
| Blizzard low level |
| driver, the |
| driverlib. |
+--------------------+
Build Options
=============
- CONFIG_WATCHDOG_HELP
Try to detect a watchdog that is about to fire, and print a trace.
This is needed on STM32, where the independent watchdog has no early
warning feature and the windowed watchdog has a very short period.
- CONFIG_PANIC_HELP
Report extra information about a panic, such as the fault address,
here shown as bfar. This shows the reason for the fault and may help
to determine the cause.
=== EXCEPTION: 03 ====== xPSR: 01000000 ===========
r0 :0000000b r1 :00000047 r2 :60000000 r3 :200013dd
r4 :00000000 r5 :080053f4 r6 :200013d0 r7 :00000002
r8 :00000000 r9 :200013de r10:00000000 r11:00000000
r12:00000000 sp :200009a0 lr :08002b85 pc :08003a8a
Precise data bus error, Forced hard fault, Vector catch, bfar = 60000000
mmfs = 00008200, shcsr = 00000000, hfsr = 40000000, dfsr = 00000008
- CONFIG_ASSERT_HELP
Report assertion failures in a vebose manner to aid debugging. When
enabled an ASSERT() which fails will produce message in the form:
ASSERTION FAILURE '<expr>' in function() at file:line
- CONFIG_CONFIGURE_BOARD_LATE
Define this to call configure_board_late() after initial system init
is complete (and after GPIOs are set up).
- CONFIG_AC_POWER_STATUS
Monitor the state of the AC power input and drive out a GPIO to
the AP indicating this state. The GPIO will be driven low when
AC power is not connected, and high when it is connected. This
uses GPIO_AC_STATUS for this purpose.