mirror of
https://github.com/Telecominfraproject/OpenCellular.git
synced 2025-12-30 10:31:02 +00:00
e3336f4c8d
STM32F0 cannot keep PWM output active when chip is in deep sleep.
The only other board that uses both CONFIG_LOW_POWER_IDLE
and CONFIG_PWM on stm32 is jerry, and this logic should also apply
to it.
Also, switch using_pwm from array to bitmask to simplify handling.
BRANCH=none
BUG=b:36173380
TEST=On AP, tell it to autosuspend hammer:
echo auto > /sys/bus/usb/devices/1-2/power/control
Then see, using idlestats, that hammer does to deep sleep.
In hammer console: pwm 0 50, see that PWM output is stable,
idlestats shows EC does not sleep.
In hammer console: pwm 0 -1, idlestats shows EC sleeps again.
Change-Id: Ic74c1905364fe4335239da95a99193d0e3e979f7
Reviewed-on: https://chromium-review.googlesource.com/541115
Commit-Ready: Nicolas Boichat <drinkcat@chromium.org>
Tested-by: Nicolas Boichat <drinkcat@chromium.org>
Reviewed-by: Vincent Palatin <vpalatin@chromium.org>
For an overview of the Embedded Controller firmware, refer to http://www.chromium.org/chromium-os/2014-firmware-summit For instructions on building from source, refer to http://www.chromium.org/chromium-os/ec-development/getting-started-building-ec-images-quickly