-separate edfa and raman_list of acceptable amplifiers to better
customize criteria between edfa and raman amplifiers
for example min gian requirement: no extended min gain range for raman
amplifiers because there is always an edfa solution, which is better for
small gains.
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
- in auto-design, Raman is already not used if lineic fiber loss >
eqpt_config.json [Span][max_fiber_lineic_loss_for_raman]
- this commit ensures that a warning is displayed even when auto-desing
is not used (when the network equipment configuration is imported from
json or xls topology)
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
EOL span ageing was added for each connector "to be fused" span
=> now, EOL ageing is only added to the last span of the fused spans
section.
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
when constraints such as include noe or disjuntion is applied
the candidates are sorted with shortest path in length first
Signed-off-by: EstherLerouzic <esther.lerouzic@orange.com>
add weight = length of fiber nodes on connections wher from_node is a fiber
add weight = 0.01 km on other edges
Signed-off-by: EstherLerouzic <esther.lerouzic@orange.com>
-add f_min & f_max frequency definition in amplifier json
-improve interpolation algorithm to support length differences between the spectrum information and the amplifier ripple and dgt frequency definition
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
new code provides default values when attribute is missing in the
eqpt_config.json, which can cause unexpected beahaviour
=> provide a warning message when a missing attribute is set to a
default value.
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
warning message when extended gain range or power requirements cannot be met
and power is reduced
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
set individual channel powers wrto the target reference power
tilt and ripple is eliminated after the Roadm
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
power mode no longer reads operational_gain:
now reads operational.dp_db
or calculate optimum dp_db from next span loss
gain_mode:
reads operational.gain_target
or use gain_from_dp
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
squash to dp
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
tolerate 3dB below min gain in amplifier selection
this is to allow selection of high power amps even if they are below min
gain
Signed-off-by: Jean-Luc Auge <jeanluc.auge@orange.com>
