ipq807x: various improvements for CIG-WF-186w

1. Using rtl8367c.c file for rtl8367S switch driver  to support vlan 
2. Configure eth0.1 as WAN and eth0.2 as LAN
3. Add mdio read/write in smi driver  followed 5.4 kernel driver
4. add mido clock setting followed 5.4 kernel driver for 186w board
5. Add eth and wifi mac address allocation based of BaseMacAddress
6. Update new bdf for 2G radio

Fixes: WIFI-12650
Signed-off-by: Ken <xshi@actiontec.com>

feeds/ipq807x/ipq807x/base-files/etc/board.d/02_network

@@ -63,7 +63,7 @@ qcom_setup_interfaces()
 		ucidef_set_interface_wan "eth0"		
 		;;
        cig,wf186w)
-		ucidef_set_interface_wan "eth0"		
+		ucidef_add_switch "switch0" "4:wan" "1:lan" "2:lan" "3:lan" "0:lan" "6@eth0"
 		;;
 	yuncore,fap650)
 		ucidef_set_interface_lan "eth3 eth2 eth1 eth0"

feeds/ipq807x/ipq807x/files/arch/arm64/boot/dts/qcom/qcom-ipq5018-cig-wf186w.dts

@@ -474,7 +474,6 @@
 
 		mdio0: mdio@88000 {
 			status = "ok";
-
 			ethernet-phy@0 {
 				reg = <7>;
 			};
@@ -485,16 +484,16 @@
 			pinctrl-0 = <&mdio1_pins>;
 			pinctrl-names = "default";
 			phy-reset-gpio = <&tlmm 35 0>;
-
+			cig_clk_div = <0xff>;
 			ethernet-phy@0 {
 				reg = <0x1d>;
 			};
 		};
 
 		realtek@29{
-			compatible = "realtek,rtl8367c";
+			compatible = "realtek,rtl8367s";
 			mii-bus = <&mdio1>;
-			realtek,extif0 = <0 0 12 1 0 1 1 1 1 2>;
+			realtek,extif0 = <0 0 10 1 1 1 1 1 2>;
 			switch = <&tlmm 35 0>;
 			phy-addr = <29>;
                         status = "ok";