mirror of
https://github.com/Telecominfraproject/wlan-ap.git
synced 2025-10-28 17:12:22 +00:00
7beac05946
**SPECIFICATION:**
- Chipset: IPQ8072A+QCN5054+QCN5024+QCA80812
- Flash: NOR-8MB AND NAND-128MB
- Memory: 1Gb DDR
- IEEE 802.11: 802.11ax/ac/b/g/n
- 44 2.4G Wi-Fi standard 802.11b/g/n/ax
- 4*4 5.8G Wi-Fi Standard 802.11 a/n/ac/ax
- 2x 1 Gbps Ethernet (QCA8081) with 802.3at PoE input support
- 1x DC Port 12V 3A
- 4x Antenna IPEX Connector, 3dBi omni antennas
- Data Rate: 3657Mbps ( 2.4G: 1182Mbps (11ax 4x4); 5.8G: 2475Mbps (11ax 4x4))
- RF Power: 2.4g ≤ 20dBm; 5.8g ≤ 19dBm
- Max Power Consumption: ≤ 22W
**BACKUP YOUR STOCK FIRMWARE:**
- Put openwrt-*-initramfs-kernel.bin to your TFTP server and rename it to initramfs.bin
- Enable serial console and enter to u-boot cli and exec these commands:
```
tftpboot <your_tftp_server_ip>:initramfs.bin
bootm
```
- Once boot completed and you get the openwrt shell execute below commands:
```
device=<divice_name>
mkdir -p /tmp/fw_backup; cd /tmp/fw_backup
rootfs=$(cat /proc/mtd | grep \"rootfs\" | cut -d: -f1)
rootfs_1=$(cat /proc/mtd | grep \"rootfs_1\" | cut -d: -f1)
dd if=/dev/${rootfs} of=rootfs_${rootfs} bs=1M
dd if=/dev/${rootfs_1} of=rootfs_1_${rootfs_1} bs=1M
cp /sys/firmware/fdt fdt.dtb
md5sum * > md5sum
tar -cvzf /tmp/${device}.tar.gz .
sum=$(md5sum /tmp/${device}.tar.gz | cut -d' ' -f1)
mv /tmp/${device}.tar.gz /tmp/${device}_${sum}.tar.gz
echo "stock fw backup saved to: /tmp/${device}_${sum}.tar.gz"
```
- Upload/save your backup to a safe place.
**STOCK FIRMWARE RECOVERY:**
- Boot initramfs image
- Upload your backed-up stock fw tarball to the device
using scp or download it from the device using wget.
- Enter device ssh cli or tty and exec:
```
cd /tmp && wget <your_web_server_ip>/${stock_fw_backup}.tar.gz`
tar -xpzf ${stock_fw_backup}.tar.gz
rootfs=$(cat /proc/mtd | grep \"rootfs\" | cut -d: -f1)
rootfs_1=$(cat /proc/mtd | grep \"rootfs_1\" | cut -d: -f1)
ubiformat /dev/${rootfs} -y -f /tmp/rootfs_${rootfs}
ubiformat /dev/${rootfs_1} -y -f /tmp/rootfs_1_${rootfs_1}
reboot
```
**INSTALLATION:**
1. initramfs method
- Put openwrt-*-initramfs-kernel.bin to your TFTP server and rename it to initramfs.bin
- Enable serial console and enter to u-boot cli and exec these commands:
```
tftpboot <your_tftp_server_ip>:initramfs.bin
bootm
```
- Once boot completed and you get the openwrt shell execute below commands:
```
cd /tmp && wget <your_web_server_ip>/factory.ubi`
export rootfs=$(cat /proc/mtd | grep rootfs | cut -d: -f1)
export rootfs_1=$(cat /proc/mtd | grep rootfs_1 | cut -d: -f1)
ubiformat /dev/${rootfs} -y -f factory.ubi
ubiformat /dev/${rootfs_1} -y -f factory.ubi
reboot
```
2. u-boot nand-factory.bin image method
- Put openwrt-*-squashfs-nand-factory.bin to your TFTP server and enter u-boot cli and exec these commands:
```
tftpboot <your_tftp_server_ip>:factory.bin
#After downloading is finished:
imxtract 0x44000000 ubi
flash rootfs
flash rootfs_1
reset
```
Signed-off-by: Shubham Vishwakarma <shubhamvis98@fossfrog.in>
43 lines
1.1 KiB
Bash
Executable File
43 lines
1.1 KiB
Bash
Executable File
#!/bin/sh
|
|
|
|
. /lib/functions/uci-defaults.sh
|
|
|
|
board_config_update
|
|
|
|
board=$(board_name)
|
|
|
|
case "$board" in
|
|
cig,wf194c4)
|
|
ucidef_set_led_netdev "wan" "WAN" "green:wan" "eth0" "tx rx link"
|
|
ucidef_set_led_wlan "wlan5g" "WLAN5G" "green:wifi5" "phy0tpt"
|
|
ucidef_set_led_wlan "wlan2g" "WLAN2G" "green:wifi2" "phy1tpt"
|
|
;;
|
|
edgecore,eap102|\
|
|
edgecore,oap102|\
|
|
edgecore,oap103|\
|
|
indio,um-345ax)
|
|
ucidef_set_led_netdev "poe" "poe" "green:wan" "eth0"
|
|
ucidef_set_led_wlan "wlan5g" "WLAN5G" "green:wifi5" "phy0tpt"
|
|
ucidef_set_led_wlan "wlan2g" "WLAN2G" "green:wifi2" "phy1tpt"
|
|
ucidef_set_led_wlan "power" "POWER" "green:power" "default-on"
|
|
;;
|
|
emplus,wap380c)
|
|
ucidef_set_led_default "power" "POWER" "ipq::led0" "on"
|
|
ucidef_set_led_netdev "wan" "WAN" "ipq::led1" "eth0"
|
|
ucidef_set_led_wlan "wlan2g" "WLAN2G" "ipq::led2" "phy1tpt"
|
|
ucidef_set_led_wlan "wlan5g" "WLAN5G" "ipq::led3" "phy0tpt"
|
|
;;
|
|
sonicfi,rap630w-311g|\
|
|
sonicfi,rap650c|\
|
|
cybertan,eww631-b1)
|
|
ucidef_set_led_default "power" "POWER" "sys:blue" "on"
|
|
;;
|
|
cig,wf196)
|
|
ucidef_set_led_default "power" "POWER" "green:status" "on"
|
|
;;
|
|
esac
|
|
|
|
board_config_flush
|
|
|
|
exit 0
|