mirror of
https://github.com/Telecominfraproject/OpenCellular.git
synced 2026-01-10 17:41:54 +00:00
686e3479f5
In the previous version of the code, we were counting ESOF (every
ms) to figure out when to clear the resume bit, and then using ESOF
counts again to wait for the USB interface to resume.
This missed the fact that ESOF (expected SOF) interrupts are not
triggered when SOF are actually received.
Somehow, this worked fine in most cases, except that sometimes the
last ESOF would race with the RXDP/RXDM going to state 2, and we
would not know that the resume completed successfully.
Let's also count SOF interrupts, and also take a received SOF as an
indicator of a successful resume.
While we're at it, trim down USB debugging messages, and add a line
when resume is successful.
BRANCH=none
BUG=b:35587173
TEST=Connect hammer, force autosuspend using:
DEVICE=$(dirname $(grep 5022 /sys/bus/usb/devices/*/idProduct))
echo 500 > $DEVICE/power/autosuspend_delay_ms
echo auto > $DEVICE/power/control
Add debugging in hammer code, make sure that usb_wake_done goes
back to 1 after resume succeeds.
Change-Id: I206c9c6b3066a3a337b6bd2370c9d0c6a9e2396c
Reviewed-on: https://chromium-review.googlesource.com/569522
Commit-Ready: Nicolas Boichat <drinkcat@chromium.org>
Tested-by: Nicolas Boichat <drinkcat@chromium.org>
Reviewed-by: Vincent Palatin <vpalatin@chromium.org>
For an overview of the Embedded Controller firmware, refer to http://www.chromium.org/chromium-os/2014-firmware-summit For instructions on building from source, refer to http://www.chromium.org/chromium-os/ec-development/getting-started-building-ec-images-quickly