Jett Rink 7e50bfd037 ppc: enter SNK mode before leaving dead battery mode ...

If we don't enable the SNK mode before leaving dead battery mode
(which does keep the inflow path open), then we will brown out
our only source of power.

BRANCH=none
BUG=b:77561535
TEST=yorp can boot into ec without battery

Change-Id: I095e3cb1ed466fd6497bbc9e7b6851fc92005c75
Signed-off-by: Jett Rink <jettrink@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/999024
Reviewed-by: Scott Collyer <scollyer@chromium.org>

2018-04-05 22:12:48 -07:00

..

battery

battery/max17055: Check/Reload the battery profile

2018-04-03 01:29:16 -07:00

bc12

bc12: add support for active low/high on all gpio signals

2018-03-09 20:05:12 -08:00

charger

scarlet: Enable charge termination only when battery is present

2018-03-31 01:56:32 -07:00

led

Nami: add keyboard backlight function

2018-03-02 22:22:34 -08:00

ppc

ppc: enter SNK mode before leaving dead battery mode

2018-04-05 22:12:48 -07:00

tcpm

TCPM: Add TCPM driver for Analogix anx7447 chip

2018-04-03 21:40:51 -07:00

temp_sensor

Nami: Add remote temperture 2 reading function

2018-02-27 05:14:31 -08:00

accel_bma2x2.c

sensor: bmi160/bma2x2: Fix the timeout value of compensation.

2018-03-26 14:41:34 -07:00

accel_bma2x2.h

driver: bma2x2: Add perform_calib

2018-03-16 13:29:58 -07:00

accel_kionix.c

driver: kionix: Add software reset flow for KX022

2018-03-19 17:04:54 -07:00

accel_kionix.h

driver: kionix: Use base accelgyro structure

2018-03-15 17:58:02 -07:00

accel_kx022.h

driver: kionix: Add software reset flow for KX022

2018-03-19 17:04:54 -07:00

accel_kxcj9.h

common: sensors: add extra sensor attributes

2017-05-18 21:05:23 -07:00

accel_lis2dh.c

driver: lis2dh: fix gain units

2018-03-19 19:21:21 -07:00

accel_lis2dh.h

driver: lis2dh: fix gain units

2018-03-19 19:21:21 -07:00

accelgyro_bmi160.c

sensor: bmi160/bma2x2: Fix the timeout value of compensation.

2018-03-26 14:41:34 -07:00

accelgyro_bmi160.h

driver: bm160: Fix minimal gyro frequency

2017-09-20 16:37:57 -07:00

accelgyro_lsm6ds0.c

driver: sensor: Remove set_resolution when NOOP

2018-03-15 21:23:30 -07:00

accelgyro_lsm6ds0.h

common: sensors: add extra sensor attributes

2017-05-18 21:05:23 -07:00

accelgyro_lsm6dsm.c

driver: lsm6dsm/lsm6dsl: Add FIFO support

2018-04-05 18:41:12 -07:00

accelgyro_lsm6dsm.h

driver: lsm6dsm/lsm6dsl: Add FIFO support

2018-04-05 18:41:12 -07:00

als_al3010.c

driver: add support ambient light sensor AL3010

2016-09-13 01:10:47 -07:00

als_al3010.h

driver: add support ambient light sensor AL3010

2016-09-13 01:10:47 -07:00

als_bh1730.c

motion: Add bh1730 as a motion sensor

2017-12-08 00:37:03 -08:00

als_bh1730.h

motion: Add bh1730 as a motion sensor

2017-12-08 00:37:03 -08:00

als_isl29035.c

ALS: Disable the ALS task if all the ALS inits fail

2015-10-02 12:55:51 -07:00

als_isl29035.h

ALS: Disable the ALS task if all the ALS inits fail

2015-10-02 12:55:51 -07:00

als_opt3001.c

driver: OPT3001: Re-order application of scale.

2018-03-14 04:07:08 -07:00

als_opt3001.h

OPT3001: Support MOTIONSENSE_CMD_SENSOR_[OFFSET|RANGE] for calibration.

2017-11-26 05:21:39 -08:00

als_si114x.c

motion: Lower jitter of Sensor->EC timestamp

2018-03-14 04:06:52 -07:00

als_si114x.h

driver: sensor: tune MAX_FREQ

2017-07-13 15:08:42 -07:00

baro_bmp280.c

motion_sense: Put set_range in common code

2017-11-17 20:18:30 -08:00

baro_bmp280.h

cleanup: motion_sense: Remove driver data structure externs

2017-06-15 23:54:00 -07:00

build.mk

TCPM: Add TCPM driver for Analogix anx7447 chip

2018-04-03 21:40:51 -07:00

gyro_l3gd20h.c

driver: sensor: Remove set_resolution when NOOP

2018-03-15 21:23:30 -07:00

gyro_l3gd20h.h

common: sensors: add extra sensor attributes

2017-05-18 21:05:23 -07:00

ina2xx.c

cleanup: DECLARE_CONSOLE_COMMAND only needs 4 args

2016-08-24 16:30:10 +00:00

ina2xx.h

cleanup: fix all the header guards

2015-06-18 19:07:00 +00:00

ioexpander_pca9534.c

Plankton: Add console command to reset USB hub

2014-09-23 06:28:38 +00:00

ioexpander_pca9534.h

cleanup: fix all the header guards

2015-06-18 19:07:00 +00:00

ioexpander_pca9555.h

driver: Add driver header for PCA9555 I/O port controller

2017-08-07 22:18:49 -07:00

mag_bmm150.c

driver: bmi160: Remove unnecessary delay

2016-11-21 18:22:56 -08:00

mag_bmm150.h

driver: BMM150: Set max frequency based on repetitions setting

2017-10-30 14:03:10 -07:00

mcdp28x0.c

chip/stm32/usart: Add flags to usart_config

2017-10-18 08:30:16 -07:00

mcdp28x0.h

cleanup: fix all the header guards

2015-06-18 19:07:00 +00:00

pi3usb9281.h

driver/bc12/pi3usb9281: Make a few functions static

2018-01-03 22:43:02 -08:00

pi3usb30532.h

Enforce compilation without system headers

2016-02-03 15:00:50 -08:00

pmic_tps650x30.h

meowth: zoombini: Mask off 5V PGOOD and COMP_C.

2017-12-18 20:33:00 -08:00

regulator_ir357x.c

cleanup: DECLARE_CONSOLE_COMMAND only needs 4 args

2016-08-24 16:30:10 +00:00

stm_mems_common.c

driver: lsm6dsm/lsm6dsl: Add FIFO support

2018-04-05 18:41:12 -07:00

stm_mems_common.h

driver: lsm6dsm/lsm6dsl/lis2dh: Use STM MEMs common functions

2018-03-19 19:21:18 -07:00

sync.c

sensors: Add driver for SYNC

2018-03-14 04:06:53 -07:00

sync.h

sensors: Add driver for SYNC

2018-03-14 04:06:53 -07:00

touchpad_elan.c

touchpad_elan: Power off when USB is suspended without wake

2018-02-05 19:08:22 -08:00

touchpad_st.c

driver/touchpad_st.c: implement touchpad fw update

2018-03-27 08:06:03 -07:00

touchpad_st.h

ec: add driver/touchpad_st.c

2018-03-26 23:33:33 -07:00

usb_mux_it5205.c

driver: add IT5205 mux driver

2017-10-31 21:49:24 -07:00

usb_mux_it5205.h

usbc: add default I2C addresses

2018-03-28 16:40:40 -07:00

usb_mux_pi3usb30532.c

cleanup: Fix gcc 5.2.1 compile errors

2015-11-11 11:00:56 -08:00

usb_mux_ps874x.c

usb_mux: Fix incorrect revision check at init for ps874x

2018-03-22 18:16:50 -07:00

usb_mux_ps874x.h

usb_mux: Fix incorrect revision check at init for ps874x

2018-03-22 18:16:50 -07:00

usb_mux_virtual.c

kevin / gru: Notify host of HPD IRQ status

2016-08-10 20:07:32 -07:00

usb_mux.c

usb_mux: Correct an error print.

2016-08-24 17:40:52 -07:00