Nick Sanders 2c5f85f666 servo_v4: extend pd task stack ...

This works around the occasional garbage packet storm
found in coral, which causes a stack overflow.

BUG=b:77336824
TEST=loop power_state:rec on coral 200x
BRANCH=servo

Signed-off-by: Nick Sanders <nsanders@chromium.org>

Change-Id: I08faf333cb0e7b7bb7016956de44f43621b950ea
Reviewed-on: https://chromium-review.googlesource.com/989215
Commit-Ready: Nick Sanders <nsanders@chromium.org>
Tested-by: Nick Sanders <nsanders@chromium.org>
Reviewed-by: Aseda Aboagye <aaboagye@chromium.org>

2018-04-02 16:26:45 -07:00

..

bds

Remove Makefile symlinks under board directory

2016-07-09 01:40:47 -07:00

bip

bip: enable CONFIG_IT83XX_FLASH_CLOCK_48MHZ to support eSPI speed of 50Mhz

2018-03-26 14:41:20 -07:00

chell

driver/charger/isl923x: Make sure CONFIG_CHARGER_NARROW_VDC is set

2018-01-10 06:02:13 -08:00

coffeecake

coffeecake: Change host high pullup from Rp1500 to Rp3000

2017-11-29 12:22:22 -08:00

coral

usbc: add default I2C addresses

2018-03-28 16:40:40 -07:00

cr50

cr50: use system_rollback_detected to detect rollback

2018-03-28 23:23:35 -07:00

dingdong

pd_log: Make PD logging more generic for general purpose logging

2017-08-02 15:02:34 -07:00

discovery

chip/stm32/usart: Add flags to usart_config

2017-10-18 08:30:16 -07:00

discovery-stm32f072

chip/stm32/usart: Add flags to usart_config

2017-10-18 08:30:16 -07:00

elm

board: In motion sensor array, remove assignment to 0

2018-03-14 07:04:02 -07:00

eve

usbc: add default I2C addresses

2018-03-28 16:40:40 -07:00

fizz

Fizz: Log DP mode entry and exit

2018-03-20 12:16:08 -07:00

glados

board: In motion sensor array, remove assignment to 0

2018-03-14 07:04:02 -07:00

glados_pd

Treat SYSTEM_IMAGE_RW_B also as RW copy

2017-09-09 02:26:16 -07:00

glkrvp

Code cleanup: Rename GPIO PCH_RCIN_L to SYS_RESET_L

2018-03-24 07:32:29 -07:00

grunt

usbc: add default I2C addresses

2018-03-28 16:40:40 -07:00

hadoken

g: CONFIG_FLASH should be optional

2016-10-02 15:19:21 -07:00

hammer

wand: Fix second UART module, remove unneeded internal pull-up

2018-03-28 19:34:19 -07:00

hoho

pd_log: Make PD logging more generic for general purpose logging

2017-08-02 15:02:34 -07:00

host

fan: Allow board to configure fans at run time

2018-03-06 09:59:21 -08:00

it83xx_evb

cleanup: it83xx: don't enable non-essential modules at default

2018-03-29 19:51:48 -07:00

jerry

stm32: Fix bkpdata accounting

2018-01-30 14:54:17 -08:00

kahlee

usbc: add default I2C addresses

2018-03-28 16:40:40 -07:00

kevin

driver: bma2x2: Add perform_calib

2018-03-16 13:29:58 -07:00

mchpevb1

board: In motion sensor array, remove more assignment to 0

2018-03-22 05:14:47 -07:00

meowth_fp

meowth_fp: enable CONFIG_HOST_COMMAND_STATUS

2018-03-22 15:24:42 -07:00

nami

Nami: Modify .output_settle_us of keyscan_config

2018-03-29 22:00:20 -07:00

nautilus

usbc: add default I2C addresses

2018-03-28 16:40:40 -07:00

npcx7_evb

npcx: remove optional CONFIG_PECI since no one is using it with npcx

2018-03-07 16:55:19 -08:00

npcx_evb

npcx: remove optional CONFIG_PECI since no one is using it with npcx

2018-03-07 16:55:19 -08:00

npcx_evb_arm

npcx: remove optional CONFIG_PECI since no one is using it with npcx

2018-03-07 16:55:19 -08:00

nucleo-f072rb

eCTS: Add nested interrupt test (Low->High)

2016-11-09 23:26:30 -08:00

nucleo-f411re

board: In motion sensor array, remove assignment to 0

2018-03-14 07:04:02 -07:00

oak

board: In motion sensor array, remove assignment to 0

2018-03-14 07:04:02 -07:00

pdeval-stm32f072

pd: Move PD_DEFAULT_STATE to a common define in usb_pd.h

2017-01-26 16:10:30 +00:00

plankton

charge_manager: Consider port in source PDO.

2017-08-11 20:10:20 -07:00

polyberry

chip/stm32/usb: Replace reset handler by generic event handler

2017-08-16 04:03:24 -07:00

poppy

charge_state_v2: Hibernate base in S5 with no AC

2018-03-28 23:23:32 -07:00

rainier

board: In motion sensor array, remove assignment to 0

2018-03-14 07:04:02 -07:00

reef

usbc: add default I2C addresses

2018-03-28 16:40:40 -07:00

reef_it8320

cleanup: it83xx: don't enable non-essential modules at default

2018-03-29 19:51:48 -07:00

rowan

board: In motion sensor array, remove assignment to 0

2018-03-14 07:04:02 -07:00

samus

board: In motion sensor array, remove assignment to 0

2018-03-14 07:04:02 -07:00

samus_pd

samus_pd: Remove 'adc' console command

2018-01-30 14:54:17 -08:00

scarlet

scarlet: Enable charge termination only when battery is present

2018-03-31 01:56:32 -07:00

servo_micro

servo_micro: default to UART3 enabled

2017-12-07 05:09:29 -08:00

servo_v4

servo_v4: extend pd task stack

2018-04-02 16:26:45 -07:00

stm32f446e-eval

chip/stm32/usb: Replace reset handler by generic event handler

2017-08-16 04:03:24 -07:00

stm32l476g-eval

eCTS: Expedite flashing time

2017-06-28 21:50:51 -07:00

strago

board: In motion sensor array, remove assignment to 0

2018-03-14 07:04:02 -07:00

sweetberry

chip/stm32/usb: Replace reset handler by generic event handler

2017-08-16 04:03:24 -07:00

tigertail

usb_i2c: Remove usb_i2c_board_enable/disable

2017-11-20 23:25:45 -08:00

twinkie

twinkie: clean-up disabled SNIFFER_HEADER_V2 code

2017-10-31 03:54:43 -07:00

wheatley

Add config for boards that cannot distinguish reset type

2018-03-26 02:07:24 -07:00

yorp

yorp: Enable Trackpad power

2018-03-31 04:34:09 -07:00

zinger

Mark reset and panic functions as noreturn

2017-11-07 15:25:17 -08:00

zoombini

usbc: add default I2C addresses

2018-03-28 16:40:40 -07:00

chell_pd

chell: Add EC/PD configuration for chell board

2015-10-12 13:15:48 -07:00

gru

gru: Initial mainboard commit

2016-05-04 16:15:02 -07:00

lux

lux: Add lux board

2018-01-10 12:58:55 -08:00

meowth

Meowth: Added initial board file.

2017-11-15 20:21:12 -08:00

minimuffin

zinger: minimuffin: add board support for minimuffin

2014-10-02 20:51:10 +00:00

oak_pd

oak_pd: change oak_pd to be a sym link to glados_pd

2015-11-04 07:08:35 -08:00

OWNERS

Add OWNERS files

2014-04-02 19:58:53 +00:00

soraka

soraka: Replace individual files symlinks by directory symlinks

2018-01-05 12:10:01 -08:00

staff

hammer: Add staff board

2017-05-16 07:47:05 -07:00

wand

wand: Add wand board

2017-12-20 05:49:34 -08:00

whiskers

board: Add support for whiskers board

2017-11-09 16:43:54 -08:00